Free 300-515 Practice Test Questions and Answers (2026)

View Mode
Q: 1
Which two frames can be configured on an Ethernet flow point? (Choose two.)
Options
Q: 2
Which is the primary function of a MPLS L3 VPN route target?
Options
Q: 3
Refer to the exhibit. CISCO 300-515 question Refer to the exhibit Router 1 is a P router in the ISP MPLS core A connected P router cannot generate an MPLS label for the router 1 loopback0 interface Which action resolves this issue?
Options
Q: 4
Which two statements about MPLS L3 VPN RDs are true? (Choose two.)
Options
Q: 5
How do PE routers exchange CE routes between remote sites?
Options
Q: 6
An engineer is investigating an EVPN traffic flow issue. Which type of traffic should the engineer allow in an EVPN Tree Service in order to fix this issue?
Options
Q: 7
Which BGP feature causes to replace the AS number of originating router with the AS number of the sending router?
Options
Q: 8
An engineer is troubleshooting an ongoing network outage. Which command should he use that can display the live log files for a process or service running on a network device?
Options
Q: 9
Refer to the exhibit. CISCO 300-515 question Which statement about this output is true?
Options
Q: 10
An engineer is investigating an MPLS LDP issue. Which command should an engineer use on a Cisco IOS XE device to display the contents of the LFIB?
Options
Q: 11
How do Ethernet virtual circuits provide a way for service providers to maximize the use of VLAN tags'-1
Options
Q: 12
Refer to the exhibit. CISCO 300-515 question A network engineer has been called to configure the four PE devices in order to enable full communication among the four CE devices connected to them. While starting to configure, he experienced a connectivity issue. Which two tasks should the engineer perform in order to begin the process correctly? (Choose two.)
Options
Q: 13
Refer to the exhibit. CISCO 300-515 question While provisioning a new BGP session between the PE and CE router, you issue the as- override command. Which statement describes modification of the prefix before being sent to the CE router (10.10.10.1)?
Options
Q: 14
In a typical service provider environment, which two tools are used to help scale PE router connectivity requirements? (Choose two.)
Options
Q: 15
An engineer noticed that PE3 is failing to accept IPv6 traffic information from PE1 The engineer confirmed that both PE3 and PE1 routers are configured accurately with IPv6 protocol To eliminate IPv6 traffic loss issue, which action must the engineer take to solve the problem?
Options
Question 1 of 20

Premium Access Includes

  • ✓Quiz Simulator
  • ✓Exam Mode
  • ✓Progress Tracking
  • ✓Question Saving
  • ✓Flash Cards
  • ✓Drag & Drops
  • ✓3 Months Access
  • ✓PDF Downloads
Get Premium Access
Scroll to Top

FLASH OFFER

Days
Hours
Minutes
Seconds

avail 10% DISCOUNT on YOUR PURCHASE

  • USE THE CODE GIVEN BELOW ON YOUR CHECKOUT
DISCOUNT10