Juniper JN0 351
Q: 1
Exhibit.
Which router will become the OSPF BDR if all routers are powered on at the same time?
Which router will become the OSPF BDR if all routers are powered on at the same time?Options
Q: 2
Two routers share the same highest priority and start time.
Options
Q: 3
You are attempting to configure the initial two aggregated Ethernet interfaces on a router but there
are no aggregated Ethernet interfaces available.
In this scenario, which configuration will enable these interfaces on this router?
A)
B)
C)
D)
B)
C)
D)
Options
Q: 4
Refer to the exhibit.
Referring to the output shown in the exhibit, which statement is correct?
Referring to the output shown in the exhibit, which statement is correct?Options
Q: 5
Exhibit.
What is the management IP address of the device shown in the exhibit?
What is the management IP address of the device shown in the exhibit?Options
Q: 6
You are receiving multiple BGP routes from an upstream neighbor and only want to advertise a single
summarized prefix to your internal OSPF neighbors. This route should only be advertised when you
are receiving these BGP routes from this neighbor.
In this scenario, which type of route should you create?
Options
Q: 7
What are two characteristics of RSTP alternate ports? (Choose two.)
Options
Q: 8
Which two statements are true about the default VLAN on Juniper switches? (Choose two.)
Options
Q: 9
Exhibit.
Why is this OSPF adjacency remaining in this state?
Why is this OSPF adjacency remaining in this state?Options
Q: 10
You have DHCP snooping enabled but no entries are automatically created in the snooping database
for an interface on your EX Series switch. What are two reasons for the problem? (Choose two.)
Options
Question 1 of 10
