Free 300-620 Practice Test Questions and Answers (2026) | Cert Empire

Refer to the exhibit. Refer to the exhibit. An administrator configures inter-VRF route leaking between Production:vrf- prod and Non-Production:vrf-nonprod. However, the route in the Non-Production:vrf-nonprod VRF to the production tenant is missing. Which action resolves the VRF route leaking issue?

An engineer must configure a Layer 3 connection to the WAN router. The hosts in production VRF must access WAN subnets. The engineer associates EPGs in the production VRF with the external routed domain. Which action completes the task?

Refer to the exhibit. Refer to the exhibit. An engineer is migrating legacy servers into the Cisco ACI environment. The requirement is to ensure that all endpoints and MAC addresses are learned properly in legacy and Cisco ACI switches. Which configuration set must be configured under the bridge domain called bd__360 to accomplish this goal?

Which two protocols are used for fabric discovery in ACI? (Choose two.)

An ACI engineer is implementing a Layer 3 out inside the Cisco ACI fabric that must meet these requirements: The data center core switch must be connected to one of the leaf switches with a single 1G link. The routes must be exchanged using a link-state routing protocol that supports hierarchical network design. The data center core switch interface must be using 802.1Q tagging, and each vlan will be configured with a dedicated IP address. Which set of steps accomplishes these goals?

A network engineer is implementing a Layer 3 Out in the Cisco ACI fabric. The data center core switches must connect to a pair of leaf switches and exchange routes via a routing protocol. In addition, the implementation must meet these criteria; • The external switch interface must use 802.1Q tagging. • Access to the internet for the ACI fabric must be the L30ut. • The L30ut must use a routing protocol that has rapid convergence time and low CPU usage. Which configuration set meets these requirements?

Refer to the exhibit. Refer to the exhibit. Which two configurations enable inter-VRF communication? (Choose two.)

An engineer needs to avoid loops in the ACI network and needs an ACI leaf switch to error-disable an interface if the interface receives an ACI-generated packet. Which action meets these requirements?

Refer to the exhibit. Refer to the exhibit. The external subnet and internal EPG1 must communicate with each other, and the L3Out traffic must leak into the VRF named "VF1". Which configuration set accomplishes these goals?

Refer to the exhibit. Refer to the exhibit. An engineer is configuring a production Multi-Site solution to provide connectivity from EPGs from a specific site to networks reachable through a remote site L3OUT. All required schema and template objects are already defined. Which additional configuration must be implemented in the Multi-Site Orchestrator to support the cross-site connectivity?