300-425.pdf
Q: 1
A wireless network consists of:
• two IOS XE controllers installed in a data center
• 9100 series APs
• corporate and a guest WLAN
The customer must high availability pair two Cisco WLCs for the client SSO. Which two design
approaches must the engineer take to meet the requirement? (Choose two.)
Options
Q: 2
During a wireless design all APs are mapped to designated controllers in case of a failure. The
controllers are located in the same data center but in different racks. An AP failed over to a controller
that was not defined on its High Availability tab. The customer does not want the AP to move back to
its defined Cisco WLCs until they manually intervene. What needs to be addressed in the design?
Options
Q: 3
The wireless survey report shows APs staggered throughout a facility, with several of them placed on
the exterior walls. Other APs are located at building corners and major turns in the structure layout.
Assuming that all survey locations are optimized with a minimum of -67 RSSI at
cell edges with 20% overlapping cells, for which purpose is this survey model used?
Options
Q: 4
An engineer must identify the network requirements for a company that has a main o®ce and 10
branch support data, voice, video, and location tracking. Which two factors must be considered?
(Choose two.)
Options
Q: 5
An enterprise network administrator is asked to set up an experimental WLAN for a collaboration
project with a local service provider. The
WLAN must be anchored to a WLC in the service provider
data center using legacy mobility mode. After the configurations are completed on the WLCs and the
firewalls in the path, the data path mobility tunnel is failing to come up. What should be performed
by the administrator to debug the issue?
Options
Q: 6
A company is in the process of relocating to a new force space and ends out that the Internet circuit
will not be ready before the move. The new building has a non-Cisco WLAN to which they can
connect. The engineer has a 12-port switch and one Cisco autonomous AP and must connect
multiple wired devices. Which additional device is needed to get all clients connected over the
workgroup bridge?
Options
Q: 7
A customer has a single anchor WLC named Anchor A. Anchor A is in a DMZ and provides guest access. The customer wants to deploy an additional anchor controller named Anchor B to provide redundancy if Anchor A fails. Which design approach should be taken for the guest WLAN priority on the foreign WLC for each anchor WLC?
Options
Q: 8
Two cisco 5520 wireless LAN controllers are managing all access points throughout the network. The
WLCs are in different locations to provide geographical redundancy a mobility group has been
configured on both WLCs and has a UP status on both controllers. The Aps in location A are statically
configured to use controller A as the primary and controller B as the secondary. If the WLC in location
A goes offline. The Aps successfully join the WLC in location, but they do not fail over to their primary
configured controller. Which configuration task fixes the issue?
Options
Q: 9
A customer has a central Cisco WLC that manages APs in FlexConnect mode. The wireless
infrastructure supports multiple small branches. One branch deploys new CCX wireless phones that
are authenticated by a central Cisco ISE via PEAP/IMSCHAPv2, and tra®c is switched
locally. The
customer must reduce the number of full authentication requests and optimize roaming for the new
phones. Which action
accomplishes the requirement?
Options
Q: 10
Clustering Cisco WLCs into a single RF group enables the RRM algorithms to scale beyond the
capabilities of a single Cisco WLC. How many WLC and APs in an RF group can the controller software
scale up to in WLC release 8.9 depending on the platform?
Options
Question 1 of 10
