Q: 2
What is the first step in the installation process of the Aruba data center solution?
Options
Discussion
B tbh, but I always wonder about edge cases where initial firmware staging happens before full OS install. On Aruba, though, OS goes in before you touch config or diagnostics. Unless they redefine install steps, B holds up here.
I don’t think it’s D. B is the right one, configuring or diagnostics come after OS install.
Had something like this in a mock recently. It starts with B since you can’t configure or test anything meaningful before the OS is installed, especially on Aruba platforms. Powering on (D) happens physically first but isn’t part of the official install process. Pretty sure B lines up with what I’ve seen, but open to corrections if Aruba docs changed.
Its B here since you always need the OS on the hardware before doing any configs or running tests. Powering on is obvious but not really an install step, and network setup comes after the OS. Pretty sure this matches Aruba docs too. If anyone did it differently, let me know!
B Pretty sure installing the OS comes first according to official docs and most exam guides.
From what I know, it's B. Installing the OS is always first in these setups.
Be respectful. No spam.
