According to the Huawei documents and resources, the chronological order during the 802.11r fast

roaming process between WACs is as follows:

2.The STA accesses the network through API. This is the initial association process before roaming.

1.The STA initiates an 802.11 FT authentication request to AP2. This is the first step of the roaming

process when the STA moves to a new AP.

3.AP2 starts the reassociation timer, and sends an 802.11 FT authentication response to the ST

A. This is the second step of the roaming process when AP2 responds to the STA’s request and sets a

timer for reassociation.

4.The STA generates and installs a P TK based on the information contained in the response frame.

This is the third step of the roaming process when the STA derives a new pairwise key for encryption.

5.The STA sends a reassociation request to AP2. This is the fourth step of the roaming process when

the STA requests to reassociate with AP2.

6.AP2 generates and installs a PTK according to PMK-RI and information contained in the request

frame. This is the fifth step of the roaming process when AP2 derives the same pairwise key as the

STA.

7.After receiving the reassociation request, AP2 disables the reassociation timer, and then sends a

reassociation reg onse to the STA. This is the sixth step of the roaming process when AP2 confirms

the reassociation with the STA and stops the timer.

8.The STA receives the response frame of AP2. The roaming process is complete. This is the final step

of the roaming process when the STA completes the handover to AP2.

Therefore,

2,

1,

3,

4,

5,

6,

7,

8

is

the

correct

answer.

Reference:

https://support.huawei.com/enterprise/en/doc/EDOC1100169459/8d79210e/configuring-wirelessmesh-networking