View Mode
Q: 11
Exhibit. F5 301a question The LTM devices LTM1 and LTM2 are configured in a Device Group (Sync Failover) with Network Failover configured on both the management and HA and Internal VLANS. and ConfigSync is confined in a Device Group (Sync Failover) with Network Failover and internal are tagged on a single trunk with subnets Connection Mirroring is configured on both the HA interlace directly connected between LTM1 and LTM2, and the management interlace is connected to a management switch. The LTM devices have four Traffic Groups defined, and both LTM devices are healthy and capable of passing traffic for any of the Traffic Groups. An LTM Specialist disconnects the cable for the HA network in an effort to test failover. Which HA functionality works in this case?
Options
Q: 12
A virtual server configuration for traffic destined to a server is as shown: F5 301a question FTP traffic is destined to the 192.168.1.101 server from the source of 192.168.2.129. Based on precedence, which virtual server accepts this traffic?
Options
Q: 13
An LTM Specialist is configuring a new virtual server on an LTM device and assigning a SNAT pool that is already is use another virtual server. Both virtual servers use the same pool members to load balance traffic. A maximum of 35,000 users needs to be able to access each virtual server ta any time. The network architecture does NOT allow the backend servers to use the LTM device as a default gateway. What is the minimum number of SNAT addresses required in the SNAT pool to meet the needs of the virtual servers?
Options
Q: 14
The picture belongs to static content, you can configure static content cache in FS to meet this demand An LTM Specialist must configure session persistence for a highly available, highly utilized web-based application. * The following requirements are provided: * http proxy setup for security persistence information available to the HA peer in case of failover The LTM Specialist needs to minimize additional burden on the LTM device to the greatest extent possible. Which persistence profile should be used?
Options
Q: 15
A pool has four members. Ail of the servers have been designed and configured with the same application. Each client's request can significantly the performance of the servers. Which load balancing method should the LTM Specialist use to maintain a relatively even load across all servers?
Options
Q: 16
An LTM Specialist needs to create a virtual server to pass TCP traffic to three pool members. Which two virtual server types should be used to meet the requirements? (Choose two)
Options
Q: 17
Refer to the exhibit. F5 301a question The http monitor is applied to a pool. All members are enabled. One server responds as follows. F5 301a question What is the resulting status of this poo! member?
Options
Q: 18
TWO BIG-IP appliances need to be configured to load balance multiple firewall in a firewall sandwich, Which health monitor setting should be used to verify that the firewalls are able to forward traffic?
Options
Q: 19
An LTM Specialist needs to add a pool that will load balance MYSOL services. It has four members, each with differing hardware platforms. All pool members are already assigned to another pool for load balancing FTP traffic. Which load balancing method is most effective when the LTM Specialist sets up the pool?
Options
Q: 20
An LTM Specialist needs to configures virtual server that uses PVA or OPVA Which virtual server type should be used?
Options
Question 11 of 20 · Page 2 / 2

Premium Access Includes

  • ✓ Quiz Simulator
  • ✓ Exam Mode
  • ✓ Progress Tracking
  • ✓ Question Saving
  • ✓ Flash Cards
  • ✓ Drag & Drops
  • ✓ 3 Months Access
  • ✓ PDF Downloads
Get Premium Access
Scroll to Top

FLASH OFFER

Days
Hours
Minutes
Seconds

avail 10% DISCOUNT on YOUR PURCHASE

  • USE THE CODE GIVEN BELOW ON YOUR CHECKOUT
DISCOUNT10