Q: 11
Which two remote access VPN solutions support SSL? (Choose two.)
Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 12
Refer to the exhibit.
Based on the debug output, which type of mismatch is preventing the VPN from coming up?
Based on the debug output, which type of mismatch is preventing the VPN from coming up?Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 13
Refer to the exhibit.
Which type of VPN is being configured, based on the partial configuration snippet?
Which type of VPN is being configured, based on the partial configuration snippet?Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 14
Which VPN does VPN load balancing on the ASA support?
Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 15
DRAG DROP
Drag and drop the correct commands from the night onto the blanks within the code on the left to
implement a design that allow for dynamic spoke-to-spoke communication. Not all comments are
used.


Your Answer
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 16
An administrator is designing a VPN with a partner's non-Cisco VPN solution. The partner's VPN
device will negotiate an IKEv2 tunnel that will only encrypt subnets 192.168.0.0/24 going to
10.0.0.0/24. Which technology must be used to meet these requirements?
Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 17
Which VPN solution uses TBAR?
Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 18
Refer to the exhibit.
The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which
type of mismatch is the problem?
The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which
type of mismatch is the problem?Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Q: 19
A Cisco ASA is configured in active/standby mode. What is needed to ensure that Cisco AnyConnect
users can connect after a failover event?
Options
Discussion
No comments yet. Be the first to comment.
Be respectful. No spam.
Question 11 of 20 · Page 2 / 2
An engineer is troubleshooting a new GRE over IPsec tunnel. The tunnel is established but the
engineer cannot ping from spoke 1 to spoke 2. Which type of traffic is being blocked?